INVAMAT 210 FACADE TAPE (INDOOR)

DataSheet

PURPOSE

The indoor facade tape is designed to provide air and vapor tightness on the inside of the building structure

• Good resistance to mechanical stresses
• Allows seam expansion up to 25%
• High material density ensures minimal air penetration

APPLICATIONЕ

1. The tape width should be chosen based on the design and internal structure of the construction joints. The width of the adhesive layer between the tape and the porous surface must be at least 10 cm.
2. When working with porous materials, use the INVAMMAT adhesive applied with a brush or roller to both glued surfaces. After applying the adhesive, allow it to dry for 10-15 minutes.
3. After the surfaces have been prepared, press the tapes and level with a roller. In case of heavier bands, the tape should be mechanically fixed until the adhesive sets.
4. For more accurate and economical use it is recommended to use INVAMAT rubber adhesive for gluing non-porous surfaces.
5. It is recommended to overlap tape on non-porous surface by 2-3 cm. At the top of the working structure, we recommend using a waterproof cover sealed with bitumen sealant to the tape at the junction.

RECOMMENDATIONS

Upon work completion, seal all overlaps and joints of tapes with INVAMAT polyurethane sealant. Junctions of tapes with asphalt, or PVC waterproofing should be made with an intermediate mechanical sheet, because the sealant may not provide the required waterproofing.

HEALTH SAFETY

Read the safety data sheet before use.
<h3DIMENSIONS

THE TAPE MAY BE CUT FOR ANY STANDARD SIZES!

TECHNICAL INFORMATION